Pretty Film
Product Detail
Pretty Film (PF-150)
No coating or hollowing required
Pretty film (PF-150) that can be used by color laser printers, or color laser copy printers with flat feed and flat output, such as OKI Data C941dn, ES9542, Konica Minolta AccurioLabel 230, for all your craft projects. Personalize and customize your project by printing unique designs on our decal paper. Transfer decals onto ceramics, glass, jade, metal, plastic materials and other hard surface.
Advantages
■ Compatible with Universal color laser printer, color laser printer-copier, or laser label printer, such as OKI Data C941dn, ES9542, Konica Minolta AccurioLabel 230
■ No coating or hollowing required, heat-resistant, weather-resistant and washable.
■ Transfer decals onto ceramics, glass, jade, metal, plastic materials and other hard surface
■ Good thermal stability and weather resistance
Pretty film (PF-150) processing video
Pretty Film (PF-150)application
Product Uasge
Recommended laser printers：
Color laser printers with flat paper feed and flat paper output, color laser printer-copiers or laser label printers are preferred, such as: OKI C5600n-5900n、C8600-8800C, Epson Laser C 8500, C 8600, Minolta CF 900 9300/9500, Xerox 5750 6250 DC 12 DC 2240 DC1256GA etc. Since the working principle of each laser printer manufacturer and model is slightly different, please test in advance which laser printer will be suitable.
Laser Printing Settings:
Paper source (S): Multipurpose tray, Thickness (T): Thick,
Best print mode, please test in advance
Step by step from water slide to heat transfer by Pretty-Film：
step 1. Laser printing：
step 2. Pre-coating：
Soak a sanitary napkin in the Pre-Coat F pretreatment liquid and gently wipe the laser-printed coating surface. Let it dry naturally for about 5 minutes.
Note: There should be no water droplets. If there are any, wipe them dry with a dry cotton ball.
step 3. Water slide：
Submerge you pre-cut decal in 55degree water for 30-60 seconds or until the middle of the decal can easily be slide around. Remove from water.
step 4. Remove bubbles
With the printed surface facing down, press the backing paper to separate it from the film, leaving the film on the craft product. Press the film and gently slide it to a suitable position. Use a rubber melon or a wet towel to gently scrape the water droplets and bubbles between the film and the craft product.
step 5. baking：
Set the baking temperature of the electric oven to 150°C~200°C
Put the ceramic cup in the electric oven, close the door, and adjust the time knob to 5~10 minutes.
When the baking time is reached, open the oven door, put on high-temperature resistant gloves,
take out the ceramic cup, and place the cup on a heat-resistant table
step 6. Film tearing：
Let it cool naturally for about 30~60 minutes and start to tear off the decal film from the corners.
Leave it for at least 24 hours to achieve the best fastness.
Finishing Recommendations
Material Handling & Storage: conditions of 35-65% Relative Humidity and at a temperature of 10-30°C.
Storage of open packages: When an open packages of media is not being used remove the roll or sheets from the printer cover the roll or sheets with a plastic bag to protect it from contaminants, if you are storing it on end, use an end plug and tape down the edge to prevent damage to the edge of the roll do not lay sharp or heavy objects on unprotected rolls and do not stack them.
